How do you hook up a large old antenna on the roof to your television?

Hooked this up to where the cable came in, split between 6 TV’s and the signal is fine. For the cost of 1 cable bill this antenna is well worth the investment. Lynda Cook Rating Good product does what it says. Jeffrey Kenney Rating This is an amazing upgrade. The quality was so good that I decided to install in my attic instead of on top of the house. I am getting 40 Channels!!! A great alternative to heavy LPA antennas.

Best ways to hook up an fm antenna onto a stereo receiver?

The caveat is that it is fussy and unique to each antenna situation. This article describes a 40M vertical antenna director, but first we need to time travel to the distant past………… Background 1: To an RF observer that is located some distance from the antenna there is a vertical dipole in place, not part of one. A visual observer would see only part of one.

Of course, the virtual part of the antenna in the ground is associated with the attendant ground losses from the quality of that ground.

May 22,  · We are putting up a antenna to receive over air broadcasts. We used the abandoned Dish bracket and box. I apologize for the sound problem. I will add caption.

You are in a poor signal area so unfortunately you dont have the choices of others on here. You will likely be limited to a single outlet without a preamp. Preamping may help a single outlet as you are picking up the barest traces of signals for most of these. Preamping will almost definately help if there is a splitter to multiple outlets.

A large UHF antenna pointed at 62 degrees. Diplex in a mid-large VHF-high antenna pointed at 62 degrees. Extra insertion loss of Jointenna may affect other stations if not already preamped. Money is no object:

Early Ford V-8 Club Forum

The boundaries of each band vary somewhat in different countries. To cover this range, antennas generally consist of multiple conductors of different lengths depending on the wavelength of the radio waves they receive. The elements of most antennas are half-wave dipoles ; metal rods half the wavelength of the signal they are intended to receive.

The wavelength of a signal equals the speed of light c divided by the frequency. The above range of frequencies is too wide to be covered by a single antenna, so often separate antennas for the VHF and UHF bands are used; or a combined antenna that has both VHF and UHF elements mounted on the same boom.

The most common way is via an antenna or cable box. Since most over the air television stations broadcast in HD signal, you can get high definition versions of most network shows using a good old fashion, rabbit ear antenna — if you live in a city or metropolitan area.

FM transmissions are line-of-sight. A hill, a coliseum, big buildings — all these things can get in the way of your FM reception and even leave you hearing the effects of multi-path interference. You get multipath interference when a signal meets an obstacle of some sort, such as a mountain. Depending on the broadcast strength, the signal might get absorbed or reflected by the mountain. Due to these issues your radio will end up with poor reception as the different paths taken by the reflected signal arrive at your receiver at different intervals.

Still, some people might experience all kinds of radio interference at home as well.

Introduction

View oberkc’s Album It is my understanding that the old antennas would work. I believe the new digital signals are all in the UHF band, so much of the older antennas longer sections are unnecessary, but so long as it has UHF capability, then all should work. Also, if you are not getting good reception, you may be able to tweak this a bit by being very precise with your antenna orientation.

Convert from Cable TV to a TV antenna. A lot of people are switching from Cable TV to a TV antenna. After reading this page if you still have questions submit the form at the bottom of the page.

Most of us relied on the batwing. And once the analog signal was done, the digital came out, we had some types of different antenna. The old batwing will still work and receive the digital signal. However, the analog can tweak the antenna around a little bit, so we can get a fairly good picture. Moreover, there are quite a number of TV antennas for the RV options. Thus, you can have the best entertainment during your drive. Hence, this article will definitely give you the best answer.

How to Hook Up TV to RV Antenna with 3 Steps For the last couple of decades, the batwing antenna has been the primary antenna that has been put on the recreation vehicles.

SNES to a LG HDTV??? Hookup questions

Getting Started collecting the “gold: A couple of years ago, my XYL heard of a person that had some “antenna stuff” to give away so she was very reluctant to tell me knowing that I was usually not one to turn down a “good deal” when I saw it, but, long story short, she let the cat out of the bag. I drove about 5 miles or so and there it was, a “gold mine” of aluminum tubing just laying there to be panned. Not only did it have the original insulated base and all that went with it, but there buried under all that metal was the working end of it, all that aluminum telescoping tubing!

I managed to load up ALL of that “antenna stuff” on top of and inside the car and proceeded home trying to evade the local “county mounties”. Enough of that CB talk!

Jun 25,  · I am trying to connect an antenna that is an old sharp tube. I have a converter box but I can’t enter channels on the TV with a remote. I have to enter it : 1M.

They are quite rare and very hard to find in such pristine condition. It still has the original patina, dark brown and copper just like the factory produced them. So many of these radios have had the patina polished away, missing the reins or the saddle. Blake has replaced all of the paper capacitors, tested and replaced bad resistors and checked all of the tubes. He performed a proper alignment, making this little five-tube, AM only radio play like new.

A very cool gift for that horse lover, or man cave. Here is another one of a kind radio design! This Abbotwares “Horse with Saddle” is seldom seen, and when found is usually missing its saddle. It came from the estate of a Doctor in Auburn, Maine, who collected only the best of each radio.

How to install the halo led projector headlight

This article has been updated for to accomodate the latest technology and terms and how they may affect how you hook up your HDTV or 3D TV. We’ll also cover 3D TV and its implications for getting everything connected. The installer will then come out and install the new box ensuring that it is connected properly. For satellite, you may need a new dish to go with the new box, but this cost is usually “absorbed” into the service fees, as long as you sign a service contract.

Component cables are fine for most purposes, and will carry high definition content at up to i resolution. The installer will also most likely connect the cable or satellite box stereo audio output to your TV or receiver as well, so that you will get sound as well as pretty pictures.

Oct 10,  · How to Connect an Over the Air TV Antenna to an old style Cathode Ray Tube TV.

What is your opinion on built in amplifiers versus stand alone? I have not tried these but they have pretty good reviews. I am buying today: Hubby says we have an HD antenna. I located an old TWC connection which is already cut. When I had new TWC, it was necessary to get a new cable from the outdoor cable box. Evidently, the installer cut the old cable when he installed the new one.

Can I leave it just hang there? Also, how do you connect the antenna to the cable jack. The antenna has a plug that goes into the wall jack.

KING Jack™ Directional Over-the-Air Antenna with Mount & Built-In Signal Meter (OA8500 & OA8501)

Now I can build a stereo system! Reply Mr D March 13, at 6: Now this old hippie can rock n roll all night long and party everyday!

The antenna doesn’t care what it’s picking up; it just passes signals along to the tuner (be it a tuner box or an integrated tuner inside your TV), which decodes them into a format that can be displayed on your TV.

My Jeeps I’m not quite understanding your coax wire you mentioned and “Stud Assembly” set up. But it depends on which style of stud assembly and coax set up. And you’ll need coax that has 2 of these or similar on it It threads on the back of the radio and the other end to the stud assembly. I’d also suggest for additional grounding that you scrape or grind away any paint or powder coating to get to shiney metal on the bottom of the mount where the ground portion touches it on this style of stud assembly.

It may be necessary to add a ground strap from that ground point to the chassis or tub in addition to that as well. But you won’t know until you tune the antenna likely anyway. The isolators will go both bottom and top of the stud assembly to isolate the antenna itself. The shielding of the coax is your ground, and you’d be drilling or using a self tapper another hole for it as it gets separated totally. Hope that answers your question. If not, more info’ would be appreciated.

Cable System or VHF/UHF Antenna System

First, the outdoor antenna. This type is almost always the “Inverted L” category, the longest part of the antenna being horizontal, and the short part leading down to the receiver, like this: A high antenna brings in lots of signal. As the antenna height decreases, the signal strength decreases. A good antenna will help to override man-made static and the internal noise generated by the set itself.

How to Hook Up an Old VCR to a New TV Step. Determine whether the back of your television has an RF port or an AV port. An RF port will be a single female port that a cable can be screwed into, while an AV port will have two female ports for an audio visual cable.

Originally Posted by Sam Spastic The cable chaser is overkill. Just try the other cables one at a time and see if one works. The cable in the main viewing room is probably hooked up to the splitter, as the previous resident was using Fios? I’ll let others comment on the antenna choice. You have tried at least one of these cables and found it unsuitable for OTA reception.

You can try all other pre drilled alternates to see if they are equally bad, or alternately you may find at least one that marginally works. But how can you find out if any of your pre drilled cable alternates preform as well as RG-6 coax, basically the coax of choice for OTA television reception? And there I suggest the solution is obvious, don’t drill a singe hole because houses have things called windows and doors. Scan TV and see what you can get and chart.

Free HD TV Using Old Fashion Antenna